Browse all practice questions for the EPRI Rigger’s Handbook Practice Test. Search by topic, open any question and review its full explanation, then test yourself in the practice quiz.

EPRI Rigger’s Handbook Practice Test course image
More practice questions

These questions are part of the practice quiz. Start practicing

  • Who performs the initial inspection on all new rigging equipment before use?
  • Do not use more than how many parts of a line when using fiber blocks?
  • Which knot can be used as a last resort rescue knot?
  • If the rope’s base capacity is 2,000 pounds, what is the basket-hitch rated load at 200%?
  • Using the opposite distance method for calculating CG, how is End1 calculated?
  • Synthetic Round Slings are rated for use at what temperature range?
  • What type of load is caused by sudden lifting, stopping or swinging?
  • For swivel hoist rings, the threaded portion length is how many times the bolt diameter?
  • Chain Slings must use only which grade range?
  • The volume of a cylinder is given by which expression?
  • What is the formula for the area of a rectangle or square?
  • Formula for IWRC
  • What is the formula to calculate the weight of a pipe?
  • Which option lists all four knot types for a rope?
  • What is the choker capacity (vertical) for Synthetic Web Slings?
  • Which of the following lists the three parts of a knot?
  • If you are using a four-leg bridle hitch, how do you calculate the load per OSHA guidelines?
  • What is the temperature range for Synthetic Fiber Rope use?
  • One cubic foot of steel weighs approximately how many pounds?
  • When removing wire rope from shipping reel or coil, what is essential?
  • A basket hitch rated at 200% implies the load rating is what in relation to the standard rating?
  • What is the correct order of rigging equipment inspections from initial use onward?
  • In rough terrain crane operation, which direction provides the most stability?
  • What is the maximum included sling angle in degrees?
  • Eyenuts are threaded fasteners with a what feature?
  • Replace rope if wire diameter wear is _____ or more?
  • In a setup using a 1-inch wire rope eye sling around a 1-inch shackle, the efficiency is approximately what percentage?
  • The diameter of a circle is defined as the distance across the circle through which point?
  • Which knot is recognized as a last-resort rescue knot?
  • Eye splice strength reduction is typically what percent?
  • Eyebolts are used for what purpose?
  • In wedge work, which dimension is adjusted?
  • Which statement about crane operation on uneven ground is correct?
  • What is the temperature range for Synthetic Web Slings?
  • The fleet angle limit on a smooth wire rope drum is given as either a degree or a ratio. Which is correct?
  • How do you convert cubic inches to cubic feet?
  • Which of the following correctly describes the typical sling angle guideline for common loads?
  • Doubling the radius of a sphere increases its surface area by what factor?
  • Deflection of the boom and pendant stretch will increase which of the following?
  • A 1-inch wire rope eye sling lifting a load with a sling around a 1-inch shackle will be how efficient?
  • Who provides direction to the equipment operator on a worksite?
  • Which terms are considered the three parts of a knot?
  • The D/d ratio is calculated using which measurements?
  • In lace reeving, which condition is observed as the main disadvantage?
  • Turnbuckles are used for what purpose?
  • Shackles are rated for max capacity under which loading condition?
  • Two-blocking occurs when the ball or block comes in contact with what?
  • For Personnel Basket Lifting, the proof test should be to what percent of rated capacity?
  • Which description best defines a Rigger?
  • What does a 1 short audible signal indicate when the crane is moving?
  • What is the temperature range for Wire Rope Clips?
  • Why is chain not suitable for impact loading?
  • What is the temperature range for rigging blocks?
  • What is the volume expression for a rectangular solid in terms of length, width, and height?
  • Which factor does the Rigger's Rule primarily address in rigging setup?
  • How do you convert inches to feet?
  • Who is a Heavy Equipment Operator in lift activities?
  • On a smooth wire rope drum, the fleet angle should not exceed which specification?
  • Jib capacity increases as the angle decreases: True or False?
  • Which statement best describes the purpose of a Below-The-Hook Lifting Device?
  • What is the formula to compute load weight from volume?
  • Shackles are rated for max capacity when use for what?
  • The perimeter of a rectangle is represented by which expression?
  • What is the maximum grade a crane can operate on if it is not level?
  • When a choker hitch angle is less than 120 degrees, how is the allowable sling load calculated?
  • Maximum included sling angle?
  • What is the D/d ratio for the relationship between sheave pitch diameter and wire rope diameter?
  • The crane's maximum capacity is determined by the boom angle and what else?
  • What are Metal Mesh Slings composed of?
  • When operating near high-voltage powerlines rated at 275 kV, what clearance is required?
  • What happens when rope is bent around sheaves or a hook?
  • What is the well-known mnemonic used to remember the wire rope clip sequence?
  • Grade 110/20 wire rope has the highest strength.
  • Circumference of a circle is defined as which of the following?
  • What is the most commonly used grade of natural fiber?
  • What unit is weight per cubic foot typically expressed in?
  • What is the standard area formula for a circle?
  • Choker hitch rating depends on choke angle and is typically what percent?
  • What is the choker capacity (vertical) for Synthetic Fiber Rope?
  • The term for ultimate load divided by the safety factor is what?
  • What does CG stand for in lifting discussions?
  • What is the maximum interval for periodic inspections of rigging equipment?
  • A short splice is what percentage as strong as the original fiber rope?
  • What temperature range applies to Shackles?
  • Eye nuts must be affixed to SAE Grade 5 / ASTM A449 threaded material.
  • How many cubic inches are in one cubic foot?
  • The maximum capacity of a crane is measured by which configuration?
  • What function will cause the load to exert leverage on the crane?
  • Which components are commonly included in Below-The-Hook Lifting Devices?
  • Synthetic Round Slings are typically made from which material?
  • Who is responsible for the safe handling of the load while operating crane/hoist equipment?
  • Who performs the frequent inspection (before, during, and after use) of rigging equipment?
  • What is the choker capacity (vertical) for cable laid wire rope slings?
  • Which of the following is NOT one of the four knot types listed for rope work?
  • What does IWRC stand for in rope construction?
  • In a regular rope lay, how are the strands laid?
  • What is the choker capacity for chain slings in vertical configuration?
  • Which statement best defines the Lift Coordinator?
  • Which statement best describes swivel hoist rings compared to eye bolts?
  • The 'Rule of thumb' minimum for wire rope to sheave ratio is
  • If the diameter D is 2 inches, what is the IWRC value using the formula D^2 x 45?
  • What material should wire rope be made of?
  • As the boom angle decreases, crane capacity _________.
  • If a four-leg bridle hitch is used and the total load is 30,000 pounds, what is the load per leg under OSHA calculation?
  • Which of the following is NOT a hitch type?
  • What is the purpose of a tag line?
  • What is the maximum angle when using multiple slings in rings?
  • Which formula gives the area of a sphere?
  • What does a 2 short audible signal indicate when the crane is moving?
  • The D/d ratio in rigging refers to what?
  • For setups using fiber blocks, the recommended maximum number of line parts is:
  • In circle calculations, which decimal value is commonly used as an approximation for pi?
  • Which description best describes Synthetic Web Slings?
  • Hoisting with a crane on outriggers, what is the most dangerous area?
  • Basket hitch is rated at what percentage?
  • Synthetic fibers offer better performance in terms of which attribute?
  • Which core type is generally associated with greater flexibility and heat resistance when used in steel wire rope?
  • What does a 3 short audible signal indicate when the crane is moving?
  • What is the temperature range for eyenuts?
  • Which statement accurately describes the Calculate CG method used in rigging?
  • Metal Mesh Slings are rated for use within which temperature range?
  • If the sling length is measured, what is the most common unit used for length in rigging measurements?
  • If the circle's diameter is D, the radius is D/2.
  • Doubling the radius of a circle increases the circumference by what factor?
  • What is the minimum lifting angle that should be used?
  • Which conditions define complex loads?
  • Dynamic loads are caused by which of the following?
  • The measurement used to determine boom length is taken from the center of the boom pin to the center of which pin?
  • Swing drift is accomplished by swinging the boom tip over the top of which components when it reaches its apex?
  • Which statement about cheater bar overload is most accurate?
  • What is the temperature range for turnbuckles?
  • Which are advantages to using IWRC over a fiber core?
  • Rigging blocks are commonly known as what?
  • Hand Chain or Lever Operated Hoist Tension Rigging is defined as what?
  • What is the formula for the volume of a rectangular solid?
  • As the crane radius decreases, the leverage the load exerts _______.
  • Eye nuts must be attached to a threaded member of which specification?
  • What is the operating temperature range for a swivel hoist ring?
  • In Calculate CG, which expression gives End1?
  • Mobile Crane Operators should be assigned to which task?
  • For a 275 kV line, which of the following is a typical required clearance?
  • Which of the following best describes the effect on nominal strength when rope is bent around sheaves or hooks?
  • What determines crane capacity?
  • Which quadrant is most stable for rough terrain cranes?
  • ASME BTH-1 is primarily concerned with which area?
  • Which statement about Synthetic Fiber Rope is true regarding tensile strength and weight?
  • When operating near high-voltage powerlines rated at 100 kV, what clearance is required?
  • Which natural fiber is commonly used as a natural fiber grade?
  • When moving a load, approximately what percentage of the crane's rated capacity is available?
  • What temperature range applies to Hooks?
  • What describes High Line Tension Rigging?
  • What minimum distance must be maintained between the closest part of the crane and any building or structure?
  • If a circle's diameter is D, the radius is equal to what fraction of the diameter?
  • When operating near high-voltage powerlines rated at 33 kV, what clearance is required?
  • What is the main support structure for an overhead gantry?
  • To what concept does the abbreviation CG refer?
  • When operating near high-voltage powerlines rated at 50 kV, what clearance is required?
  • The cylinder volume is calculated using which formula?
  • Complete the sentence: Never _____ wind the wire rope from Top to Bottom.
  • The area of a circle depends on which variable?
  • The plane of the shouldered eyebolt shall be aligned in the direction of what?
  • What is the temperature range recommended for eyebolts?
  • The Rule of Thumb for wire rope to sheave ratio is 20:1.
  • What is the temperature range recommended for wedges?
  • If the boom angle becomes shallower, what happens to the crane's capacity?
  • An eye splice reduces the strength of fiber rope by what range?
  • Which statement is NOT a Sling Protection ABC characteristic?
  • When traveling with the load, what percent of crane capacity can be used?
  • On some come-a-long hoists, the handle will flex when?
  • What must be removed from wire rope before inserting into a wedge?
  • Using a cheater bar or snipe can overload a jack.
  • What is the volume of a cube with side length s?
  • What is the sling tension formula?
  • In a rigging block, as the included angle decreases, the load what?
  • In lace reeving, what is the main disadvantage?
  • How was the boom angle measured?
  • Which standard governs the design of lifting devices?
  • Which items are examples of Below-The-Hook Lifting Devices?
  • For Wire Rope Slings with Fiber Core, what is the acceptable temperature range?
  • How is boom length measured on a crane?
  • Synthetic Round Slings configurations can be which designs?
  • What temperature range applies to Rings and Links?
  • Which statement correctly describes crane capacity determinants?
  • What defines a common load in terms of sling angle?
  • Which expression represents the circumference of a circle in terms of diameter?
  • Which statement about a lifting beam used in hoisting operations is true?
  • The Lift Team should consist of?
  • At a 60-degree angle, the sling leg load is what percentage?
  • The windspeed unit used for the consultation rule is which?
  • Is the pin larger than the body of a shackle?
  • Choker capacity for Synthetic Round Slings in vertical is what percent?
  • If a circle's circumference is expressed using the radius, which formula is correct?
  • Which statement best describes Independent Wire Rope Core (IWRC) in terms of strength and temperature performance?
  • What is a Below-The-Hook Lifting Device?
Subscribe

Get the latest from Examzify

You can unsubscribe at any time. Read our privacy policy